Features of waterjet cutting garnet sand
Waterjet cutting garnet sand,also called water cutting sand,water jet cutting sand,waterjet sand etc,normally the sizes are 60mesh or 80mesh.Garnet water jet sand produced by our factory has been fully automated from raw materials to finished products.It goes through 4times crushing,6times water washed,3times magnetic separationa and 4times sieveing to make sure the quality best.
Garnet sand is a kind of natural abrasives which can be used for ultra-high pressure water jet cutting.
Waterjet cutting is the fastest growing machine tool technology in the world,which is used for cutting soft material such as rubber,foam,food and paper etc,when small amount garnet sand is added,it can cutting any hard materal such as metal,stone,compound etc.
The features of waterjet cutting garnet sand from our factory:
1.Garne sand is ferroaluminum garnet,which has high hardness lower than brown fused alumina,sharp edges,fast cutting speed.
2.High purity,washed too many times,no dust at all.
3.Very strict particle size distribution,uniform particles makes cutting surface smooth and flat.
4.No big grains which will block the pipe,then reduce wear on accessories to save cost etc
